| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Wing tube and access port http://www.hobie.com/au/en/forums/viewtopic.php?f=15&t=66738 |
Page 1 of 1 |
| Author: | Jdm [ Wed Jun 17, 2020 11:37 am ] |
| Post subject: | Wing tube and access port |
Hi all, longtime Miracle 20 sailor here - just picked up a 17 Sport for days when I can’t find crew. I have one wing tube repair to do; found great info here on the forums and planning on tackling this weekend. The boat has no access ports currently - so that will be first. I’ve done access ports before on a 16 but never on a 17. Any recommendations on 5” or 6” and flat vs curved? Thanks for any help. Jim |
|
| Author: | srm [ Wed Jun 17, 2020 1:37 pm ] |
| Post subject: | Re: Wing tube and access port |
5” should be fine. They actually require a 5-1/2” hole, so do the repair before installing the port flange and you will have an extra 1/2” to work in. Curved is preferred but I believe they are no longer available. So you can use flat and bed the flange in silicone or epoxy to fill the gap. Just don’t over-tighten the mounting screws or you will bend the flange which will make installing and removing the plate more difficult. sm |
|
| Author: | Jdm [ Wed Jun 17, 2020 7:07 pm ] |
| Post subject: | Re: Wing tube and access port |
Thank you ! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|