Hobie Forums
http://www.hobie.com/au/en/forums/

new 2 me H17
http://www.hobie.com/au/en/forums/viewtopic.php?f=15&t=8944		 Page 1 of 1
Author:  Banzilla [ Wed Mar 19, 2008 7:29 am ]
Post subject:  new 2 me H17
If all goes well over the next 2 weeks, I will be getting a 1990 H17. From what I can remember of the boat, is it does not have the cross bar between the Bridle wires. Is this a "Special Bar" Hobie only for some reason, or can I make it if at some time I want to add a jib?

Thanks
Sam
Author:  MBounds [ Wed Mar 19, 2008 8:00 am ]
Post subject: 
The bar is not that special - it's the same extrusion as the boom.

It's the end fittings that are the trick.

I've got the entire Sport conversion kit (spreader bar, bridles, forestay, roller furler, white jib - never even unrolled, jib sheet cleats & sheets and the boomlet for the main). Hobie list price is about $1,200. Make me an offer.
Author:  Banzilla [ Wed Mar 19, 2008 8:10 am ]
Post subject: 
MBounds wrote:
The bar is not that special - it's the same extrusion as the boom.

It's the end fittings that are the trick.

I've got the entire Sport conversion kit (spreader bar, bridles, forestay, roller furler, white jib - never even unrolled, jib sheet cleats & sheets and the boomlet for the main). Hobie list price is about $1,200. Make me an offer.


Don't say that outloud, somebody might here you :)

Please Email me at

banzilla1 at yahoo dot com
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/