| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Rudder Cams http://www.hobie.com/au/en/forums/viewtopic.php?f=17&t=12468 |
Page 1 of 1 |
| Author: | Triggs [ Wed May 13, 2009 11:43 am ] |
| Post subject: | Rudder Cams |
Couple questions. My rudder cams aren't flipping up when I raise the rudders. Is it possible to adjust the tension of the spring underneath? I would like to put new rudder cams on but the ones in it now are original and rivetted in. What size drill bit is best to remove the rivet? |
|
| Author: | mmiller [ Wed May 13, 2009 3:48 pm ] |
| Post subject: | Re: Rudder Cams |
There is a detailed FAQ on cams here: http://www.hobiecat.com/community/viewtopic.php?f=18&t=467 The drill can be between 3/16 and 1/4. Be carefull to drill JUST the head off the pin if uing the larger bit. Best to just thin it and then punch it through which will tear the remainingbhead off if thin enough. |
|
| Author: | gary eudy [ Sun May 17, 2009 4:18 pm ] |
| Post subject: | Re: Rudder Cams |
Use the sister screw kit for the cams. It will be a big help when a rudder cam breaks order a few spare cams just in case Gary |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|