Wire measurements are from bearing surface to bearing surface:
So the measurements are from the inside of the thimble - also known as "pin-to-pin"
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Pigtail Measureing http://www.hobie.com/au/en/forums/viewtopic.php?f=17&t=53934 |
Page 1 of 1 |
| Author: | hobiemark [ Sat Feb 14, 2015 1:36 pm ] |
| Post subject: | Pigtail Measureing |
I ended up with some furler pigtails, and need to know how to measure them so I can Id what boats they are for. I have the wire guide, it states 10 in not including the swivel for the 14. Is that from the end of the thimble to the end of the thimble I would assume? They are supposed to be for hobie 14's. thanks. |
|
| Author: | MBounds [ Sun Feb 15, 2015 5:09 am ] |
| Post subject: | Re: Pigtail Measureing |
Wire measurements are from bearing surface to bearing surface: So the measurements are from the inside of the thimble - also known as "pin-to-pin" |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|