H14 Hull spacing dimensions for trailer needed

My H14 is lying on lake Soustons in SW France and so I cant measure it up for a flat bed road trailer that I am adapting to carry it by fitting 2 cross bars of about 8 feet each to the front and rear. My concern is that the wheel mudguards wont fit between the centre of hulls and I'll have to raise the bars or the supports. I also need to know where to position the supports

So, could someone please measure:

The distance between the bottom points/Vs of the hulls (ie V - V) at:

a) the centre of the boat
b) under the front tramp cross bar
c) under the rear tramp cross bar

Thanks in anticipation.

Huw

It's approximately

80" at the front crossbar
82" at the rear crossbar

I have 60" outside to outside of wheel fenders of this trailer with about 5-6" clear

note these were taken off my '84 project boat that has four H16 masts on the trailer, below the boat.
I had to set the measuring tape on the ground and eyeball it.

Viva la 14 !!!

_________________
1984 H16 "Mister Rogers"
1984 H14 "Sundays"
2000 H20 "Jet"
Sheet In, Max Out

Thanks flatlander that's useful