You are talking about replacing the plug's housing right?
A liberal amount of Silicone in and around the hole then push the housing in and add the two screws. Don't over-tighten the screws.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Judy Roughton Mardis http://www.hobie.com/au/en/forums/viewtopic.php?f=17&t=70227 |
Page 1 of 1 |
| Author: | judyroughton [ Fri Aug 26, 2022 9:24 am ] |
| Post subject: | Judy Roughton Mardis |
I am replacing the drain plug pieces (don't know what it's called) for my Hobie 14. They are cracked and letting water in even with the plugs screwed in. Do I use epoxy or a gasket to seat to the hull? |
|
| Author: | mmiller [ Fri Aug 26, 2022 3:31 pm ] |
| Post subject: | Re: Judy Roughton Mardis |
You are talking about replacing the plug's housing right? A liberal amount of Silicone in and around the hole then push the housing in and add the two screws. Don't over-tighten the screws. |
|
| Author: | judyroughton [ Fri Aug 26, 2022 3:37 pm ] |
| Post subject: | Re: Judy Roughton Mardis |
Yes, that’s exactly what I have. Thank you so much for clearing that up for me. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|