| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Request for Technical drawing http://www.hobie.com/au/en/forums/viewtopic.php?f=17&t=71549 |
Page 1 of 1 |
| Author: | Trimaran Driver [ Fri Jul 12, 2024 7:43 am ] |
| Post subject: | Request for Technical drawing |
This is for Matt Miller: In another post some time ago, you shared the print showing cross section and assembly dimensions for the H16 mast. Is such a print available for the H14/14T mast? If so, could you email me the link? TIA David Jones |
|
| Author: | mmiller [ Fri Jul 12, 2024 9:49 am ] |
| Post subject: | Re: Request for Technical drawing |
Emailed. |
|
| Author: | hobiemark [ Sat Jul 13, 2024 4:04 am ] |
| Post subject: | Re: Request for Technical drawing |
I would like a copy of that as well. Thanks Mark |
|
| Author: | mmiller [ Mon Jul 15, 2024 10:54 am ] |
| Post subject: | Re: Request for Technical drawing |
emailed |
|
| Author: | Gunthen [ Mon Jun 09, 2025 2:02 am ] |
| Post subject: | Re: Request for Technical drawing |
@ Matt Miller, any chance you can please send me this drawing as well. I am re-rigging some training dinghies using broken Hobie 14 and 16 spars and need to manufacture some custom mast steps and hounds. Any chance you have a .dwg drawing file of the Hobie 14 and 16 spars? Many thanks. |
|
| Author: | mmiller [ Mon Jun 09, 2025 1:10 pm ] |
| Post subject: | Re: Request for Technical drawing |
Emailed |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|