| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Corner casting replacement http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=10096 |
Page 1 of 1 |
| Author: | mmadge [ Sun Jul 20, 2008 5:53 pm ] |
| Post subject: | Corner casting replacement |
I have to replace the front port corner casting on my hobie 16.If anyone has some insight into this give me some heads up please.Some initial questions I have are as follows. Should I tighten the dolphin striker nut before or after putting in rivits? How important is it to have boat level when putting back together? Any suggestions on a marine sealent to put in castings to reduce squeaking. Does the casting come with bolt hole already drilled? |
|
| Author: | mmiller [ Mon Jul 21, 2008 3:37 pm ] |
| Post subject: | |
Answered in the 16 forum. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|