I downloaded and printed out the hull template for my H16, the scale at the top of the template is supposed to be 6 INCHES? Any help would be greatly appreciated!!
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hull Bottom Template Question http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=10161 |
Page 1 of 1 |
| Author: | AlanRV8 [ Sat Jul 26, 2008 1:40 pm ] |
| Post subject: | Hull Bottom Template Question |
I downloaded and printed out the hull template for my H16, the scale at the top of the template is supposed to be 6 INCHES? Any help would be greatly appreciated!!
|
|
| Author: | MBounds [ Sat Jul 26, 2008 1:49 pm ] |
| Post subject: | |
That's what it says. "Measurements show original size of document in inches" What's so complicated about that? |
|
| Author: | AlanRV8 [ Sat Jul 26, 2008 1:57 pm ] |
| Post subject: | |
That would suggest when printing out the template, that scale should come out at its original size, right? |
|
| Author: | AlanRV8 [ Sat Jul 26, 2008 2:51 pm ] |
| Post subject: | |
Thanks for the reply, but the problem has been resolved. |
|
| Author: | MBounds [ Sat Jul 26, 2008 2:53 pm ] |
| Post subject: | |
Not necessarily. The scale is there so you can (with some trial and error) get it to print at the right scale. Most image editing programs allow you to adjust the scale of the print output. Alternatively, print it out and put it on a copier with zoom capabilities. Either blow it up or shrink it depending on whether it's too big or too small. |
|
| Author: | AlanRV8 [ Sat Jul 26, 2008 7:46 pm ] |
| Post subject: | |
I had a printer software problem....it wouldn't let me blow it up to the proper size. Reloaded the software and it worked....gee, I feel dumb.... 
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|