| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| help with loose cleat http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=13483 |
Page 1 of 1 |
| Author: | BradO [ Tue Aug 04, 2009 8:10 am ] |
| Post subject: | help with loose cleat |
I have a loose jib cleat on my H16 mast. What is best, drill new holes, reposition and rivet in, or can I drill the loose rivets out and rivet into the same holes. I suspect that this depends on how much the old holes have been distorted. Any advice that can be offered would be appreciated. Thanks, Brad |
|
| Author: | BradO [ Tue Aug 04, 2009 6:27 pm ] |
| Post subject: | Re: help with loose cleat |
I found what I needed in an old post. Thanks -Brad |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|