Hobie Forums
http://www.hobie.com/au/en/forums/

Help with new cams
http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=23158		 Page 1 of 1
Author:  blord5 [ Fri Apr 09, 2010 6:53 pm ]
Post subject:  Help with new cams
I've just installed new cams but they don't rotate up into the casting the same:

Image Image

Should I correct this by filing away some of the irregularities in the casting on the right hand one (in pics) or leave it alone? I don't know how far the cam is supposed to rotate up.

Thanks.
Author:  MBounds [ Sat Apr 10, 2010 8:59 am ]
Post subject:  Re: Help with new cams
The photos are awfully small, but the casting on the right has the correct position of the cam.

The one on the left is installed incorrectly - it's rotated too far back. The plunger should seat against the detent on the bottom of the cam to keep it from rotating back too far.
Author:  blord5 [ Sat Apr 10, 2010 1:16 pm ]
Post subject:  Re: Help with new cams
Actually, I haven't put in the plungers yet. Busy making my 3/4" by 10 thread chaser today.

But now I know that when they're installed, the cams won't rotate up that far. Thought I'd better check before I screwed up. Learning as I go.

Thanks for the quick response.

Even found a Hobie kayak dealer in the next town over today, who's willing to put my parts orders together with his so I won't have to pay shipping. Made my day!
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/