| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| gudgeons pulled http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=35260 |
Page 1 of 1 |
| Author: | bones [ Fri Apr 29, 2011 9:11 pm ] |
| Post subject: | gudgeons pulled |
Quick question for the repair gods... While un-winterizing my 1977 h16 this spring, I noticed my top gudgeon has pulled from the transom. Both screws had drifted/pulled out. Not wanting to buy the newer one-piece unit, I'm thinking I simply need to tighten the screws...hopefully they are not stripped out. If they aren't stripped and will re-tighten, can I put a dollop of West System followed by some 3M 5200 around the head for sealing? If they are stripped, can I fill the old holes, re-drill, and do as aforementioned? Thanks ya'll bones |
|
| Author: | Daredevil [ Sat Apr 30, 2011 6:22 am ] |
| Post subject: | Re: gudgeons pulled |
Buy a 1/4-20 tap, #7 drill and some 1/4-20 stainless bolts 1. Drill holes 2. Rup tap through, very easy since it is aluminum 3. Insert bolts |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|