| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hobie gel putty-what happened? http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=35481 |
Page 1 of 1 |
| Author: | havana daydreamin [ Tue May 10, 2011 6:35 pm ] |
| Post subject: | Hobie gel putty-what happened? |
I'm confused and obviously doing something wrong. I have Hobie's gel putty. As I recall, the directions were three drops catalyst (MEK )per one ounce putty. Mixed well, but remains soft after applied in a few scratches. Any suggestions folks? Confirmed: 1 idiot + polyester gel putty= 1 sticky idiot |
|
| Author: | MBounds [ Tue May 10, 2011 6:49 pm ] |
| Post subject: | Re: Hobie gel putty-what happened? |
3 drops is not enough per oz. More like 10 or 15 to get it to go off in < 30 minutes. It should eventually go off - heat will help get it going. |
|
| Author: | havana daydreamin [ Thu May 12, 2011 6:49 pm ] |
| Post subject: | Re: Hobie gel putty-what happened? |
Thanks for the help Matt. Will try again. |
|
| Author: | MBounds [ Thu May 12, 2011 7:04 pm ] |
| Post subject: | Re: Hobie gel putty-what happened? |
Remember, the reaction is greatly influenced by temperature, and it's exothermic. 15 drops on an 80° day will melt a plastic cup when it goes off. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|