| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Bent upper mast section on Holder 12 http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=52763 |
Page 1 of 1 |
| Author: | sailorsam [ Wed Sep 03, 2014 2:25 pm ] |
| Post subject: | Bent upper mast section on Holder 12 |
I am the new owner of a Holder 12 which had a serious accident which cracked the upper mast section. It was repaired with a weld but it seems to have an aft bend in it. Is this normal or should I try to straighten it out. It is an aluminum mast. |
|
| Author: | mmiller [ Mon Sep 08, 2014 3:22 pm ] |
| Post subject: | Re: Bent upper mast section on Holder 12 |
Should be straight. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|