| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| PL Premium?? http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=57774 |
Page 1 of 1 |
| Author: | paulson [ Fri May 27, 2016 8:44 am ] |
| Post subject: | PL Premium?? |
Hi Folks, I picked up a free H16 a few weeks back. The hull tops are soft enough that most of you would probably have left it in a dumpster. I've used West System for most of the hull tops, but it's still making crunchy sounds. I read where someone used Locktite PL Premium with good success. Reasoning that A) I'm not going to buy replacement hulls for this thing and scrapping it is a likely outcome, B) the boat is of little use to anyone as is, and C) PL Premium is about $7 per tube, is there any danger in using it to sure up my hulls? Thanks! |
|
| Author: | hobiesrock [ Thu Jul 14, 2016 5:52 am ] |
| Post subject: | Re: PL Premium?? |
Git rot is the go to for de-lam. Sticky stuff that cures flexible. Keep your eye out for another set of hulls/boat. Sent from my SCH-I545 using Tapatalk |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|