3/16" x 1/2" panhead SS rivets.
You may also want to borrow/rent/buy a heavy duty hand rivet tool like the Marson VHR-2, since the smaller hand held ones are hard to use on these larger SS rivets.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| rivet material on HC16 ? http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=59791 |
Page 1 of 1 |
| Author: | jdb666 [ Sat Jan 14, 2017 3:28 am ] |
| Post subject: | rivet material on HC16 ? |
Hi I took apart the cross beams from my HC16 It was not easy to drill the rivets. Are they also 6061 T6 Aluminium ? Or stainless steel ? Thx JD |
|
| Author: | srm [ Sat Jan 14, 2017 4:43 pm ] |
| Post subject: | Re: rivet material on HC16 ? |
Stainless. sm |
|
| Author: | Tim H16 [ Mon Jan 16, 2017 11:47 am ] |
| Post subject: | Re: rivet material on HC16 ? |
3/16" x 1/2" panhead SS rivets. You may also want to borrow/rent/buy a heavy duty hand rivet tool like the Marson VHR-2, since the smaller hand held ones are hard to use on these larger SS rivets.
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|