| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| welding beams ?? or beam cross section cad file ? http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=59818 |
Page 1 of 1 |
| Author: | jdb666 [ Thu Jan 19, 2017 3:19 am ] |
| Post subject: | welding beams ?? or beam cross section cad file ? |
Hello I plan to transform my HC16 this will imply cutting and adding new tubes to the platform. I have 2 option : welding but i am not sure the extruded aluminium is good for this ? Milling blocs of Al which will adapt on the beam. Does anyone knows if cad files of the cross sections of the beams cross and long section are available somewhere ? Thanks JD |
|
| Author: | MBounds [ Fri Jan 20, 2017 8:51 pm ] |
| Post subject: | Re: welding beams ?? or beam cross section cad file ? |
No and no. Welding will remove the temper from the aluminum - for small repairs, it's OK, but not for real structural work. There are no CAD files that I know of for the extrusion section. You're probably best off just cutting a section and digitizing it. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|