Hobie Forums http://www.hobie.com/au/en/forums/ |
|
h16 rudder bushing install locations http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=59910 |
Page 1 of 1 |
Author: | cvaty [ Wed Feb 08, 2017 8:26 am ] |
Post subject: | h16 rudder bushing install locations |
i've seen a video where a guy installed 4 on each side talking to the owner of cincinnati sailing he said two a side should be all i need where do the two go? attached is a picture of the casting please let me know: https://drive.google.com/open?id=0B6tZr ... 2lhRFczNU0 |
Author: | flatlander [ Wed Feb 08, 2017 5:16 pm ] |
Post subject: | Re: h16 rudder bushing install locations |
TWO and FOUR |
Author: | Tim H16 [ Thu Feb 09, 2017 8:51 am ] |
Post subject: | Re: h16 rudder bushing install locations |
Joseph Bennett made a great video in 2012: Service Your Hobie Rudders: https://www.youtube.com/watch?v=7jfn8f93XiQ At the 5:00 minute mark, he shows how to install the rudder bushings (4 per rudder casting). |
Author: | cvaty [ Fri Feb 10, 2017 12:48 pm ] |
Post subject: | Re: h16 rudder bushing install locations |
so what's the consensus then... two a side or four? is it just cost savings to use two and the extra couple might help tighten things up further.. or is four simply overkill... also i'd have to drill trough the point labeled ONE to get to TWO so the extra work installing a few extras wouldn't be much... any further thoughts on this before i begin? |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |