Hobie Forums
http://www.hobie.com/au/en/forums/

Holder 12 missing upper mast section.
http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=66962		 Page 1 of 1
Author:  Red Cat [ Fri Jul 17, 2020 10:12 am ]
Post subject:  Holder 12 missing upper mast section.
Hi,

I have just bought a Holder 12.

No upper mast section or sail. Yeah, I know, but it was real cheap.

Is anybody able to send me the upper mast section dimensions so I can build a new section out of fg.

I need an idea of how it connects to the lower section. Does it just slip over/in?

Is the whole thing tapered or straight? Need an idea to build a new sail.

Thanks in advance.
:)
Author:  mmiller [ Fri Jul 17, 2020 10:43 am ]
Post subject:  Re: Holder 12 missing upper mast section.
Slips inside the lower. A piece of Windurfer mast would work.

Image
Author:  Red Cat [ Fri Jul 17, 2020 11:24 am ]
Post subject:  Re: Holder 12 missing upper mast section.
That's great thanks. That was so quick.

Yes I think an old windsurfer mast and a saw will be quickest and least hassle.

Good job, Thanks
Ian
Author:  Red Cat [ Fri Jul 17, 2020 11:39 am ]
Post subject:  Re: Holder 12 missing lower mast section.
Actually. now I have read the diagram and looked at what I actually have. It seems I have the upper section, but am missing the lower section.

Is there a spec for the lower mast section?

Any details would help.

Thx Ian
Author:  Red Cat [ Fri Jul 17, 2020 11:42 am ]
Post subject:  Re: Holder 12 missing upper mast section.
Actually, is the upper section the same as the upper section, but without the Cap in the end?

Can I just remove the end cap, move the upper section to the lower and insert a cut-off windsurfer mast as the upper section?

Thx Ian
Author:  mmiller [ Fri Jul 17, 2020 11:50 am ]
Post subject:  Re: Holder 12 missing upper mast section.
The lower was aluminum. Maybe best to use a whole windsurf mast.

Image
Author:  Red Cat [ Fri Jul 17, 2020 12:10 pm ]
Post subject:  Re: Holder 12 missing upper mast section.
That's great thanks.

I will make it work.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/