Rivnuts are awesome
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Fixing stripped holes in aluminum http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=67176 |
Page 1 of 1 |
| Author: | Hobiecowboy [ Thu Aug 13, 2020 8:32 pm ] |
| Post subject: | Fixing stripped holes in aluminum |
I accidentally stripped the holes where the mast rotation prevention line jam cleat is mounted. Hadnt been able to figure out what do do because I didn’t want to drill new holes. Solution: drill the holes out just enough to clean them up then insert a rivet nut. Then using a rivet nut installation tool (which is just a simple hand tool). Best solution to stripped holes for pretty much anything metal |
|
| Author: | paragon1970 [ Fri Aug 14, 2020 9:20 am ] |
| Post subject: | Re: Fixing stripped holes in aluminum |
Rivnuts are awesome
|
|
| Author: | MarkB. [ Fri Aug 14, 2020 2:47 pm ] |
| Post subject: | Re: Fixing stripped holes in aluminum |
Word. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|