| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| 5 inch break in aluminum bottom section - to weld or not? http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=69881 |
Page 1 of 1 |
| Author: | HoboDan [ Wed Jun 08, 2022 6:38 pm ] |
| Post subject: | 5 inch break in aluminum bottom section - to weld or not? |
I am going to attempt to MIG weld a break/gap about 5 inches long and pushed out on a hobie wave 13. I can weld aluminum. Any opinions? New one is $689 US, plus very expensive freight as its oversize. Also, Dont want to lose all Summer not ailing waiting for new one. So, I am going to weld it up regardless, cant break it anymore than it is. Order new one if the weld get stressed. I would upload a pic, but I wont use an online intermediary storage services. Too bad you cant just upload an image directly. Just take my word, its a bad break in the aluminum, no idea how it got there. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|