Hobie Forums http://www.hobie.com/au/en/forums/ |
|
Hobie i12s loses air at the mirage drive shaft http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=70096 |
Page 1 of 1 |
Author: | UweK [ Wed Jul 27, 2022 1:41 am ] |
Post subject: | Hobie i12s loses air at the mirage drive shaft |
Hello, My i12s is losing air at the Mirage drive bay. My local German dealer can't help me and asked me to find help on the international Hobie forums: so here I am. My two main questions are: -Which glue should I use? The leak is between the rubber material and the hard plastic of the drive shaft. - how should I proceed when gluing? Should I try to loosen the whole edge or use a syringe to squeeze the glue into the "loose" areas. Here how it looks like Many thx Uwe |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |