| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| What kind of EPOXY? http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=7044 |
Page 1 of 1 |
| Author: | -=koLLac=- [ Mon Jun 18, 2007 9:58 am ] |
| Post subject: | What kind of EPOXY? |
I have a small soft spot too, I pretty much get the technique, I just need a pointer in what kind of epoxy to get. what brand, where is it cheapest to buy? Thank you! Matt |
|
| Author: | mmiller [ Mon Jun 18, 2007 2:31 pm ] |
| Post subject: | Git Rot... |
Git Rot by Boat Life. http://www.hobiecat.com/community/viewtopic.php?t=1156 |
|
| Author: | kevfran99 [ Wed Jun 27, 2007 12:27 pm ] |
| Post subject: | |
Hopefully this isn't too late for your repair, but I had two soft spots on my hulls and I used git rot on one of them and went with the cheaper West Marine brand of penetrating epoxy and it worked just as well.....it's also cheaper! Best of luck! |
|
| Author: | Hobie Nick [ Thu Jun 28, 2007 9:59 am ] |
| Post subject: | |
Use the git rot. It is well established that it works, and it is not that expensive when you compare it to a hull failure. Spend the extra few dollars and do it right. |
|
| Author: | kevfran99 [ Thu Jun 28, 2007 10:07 am ] |
| Post subject: | |
used both on one of my hulls in two different spots....the west marine was cheaper and easier to work with and it's just as hard as the git rot repair i did! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|