Hobie Forums
http://www.hobie.com/au/en/forums/

Delrin rudder cam bolt - metric size confirmation
http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=71812		 Page 1 of 1
Author:  Yuroon [ Tue Feb 04, 2025 2:24 am ]
Post subject:  Delrin rudder cam bolt - metric size confirmation
Hi y'all.

Not another Delrin rudder cam bolt topic, but I am just looking for confirmation of the metric size.
It looks like M18 x 2 to me, but I want to be absolutely sure before I clean out the threads with a thread tap.

Can anyone confirm or correct?

Thank you so much!
Author:  Tim H16 [ Thu Feb 20, 2025 8:33 am ]
Post subject:  Re: Delrin rudder cam bolt - metric size confirmation
Whenever I need to clean the threads in the lower rudder casting where the delrin screw is I use a 3/4" x 6 1/2" bolt with #10 threads.

This picture is from: "Rebuilding the Hobie Rudder Cam Assembly, Controlling When and Where Your Rudders Kick Up" by Gary Willcox

Image
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/