| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hobie Wave, JIB SHEET CLEAT WELL NUTS TO REMOUNT ? http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=72242 |
Page 1 of 1 |
| Author: | zimmerj [ Tue Mar 03, 2026 12:59 pm ] |
| Post subject: | Hobie Wave, JIB SHEET CLEAT WELL NUTS TO REMOUNT ? |
(Admin edits... this is a Hobie Wave. If there are tracks that the trampoline attaches to the hull (Looks like it)... it would be a Club version) I have a Older Hobie Wave, and just recently the jib sheet cleat broke off the the hull... Looks like original well nuts corroded. So I am looking on advice to replace ( Rubber Well Nuts or Thread Brass Inserts ) and any tips on sizes before I go drilling an poking around. 
|
|
| Author: | mmiller [ Wed Mar 04, 2026 12:05 am ] |
| Post subject: | Re: Hobie Wave, JIB SHEET CLEAT WELL NUTS TO REMOUNT ? |
Installing a small deck port in the deck above this area would allow thru bolts and backing washers/nuts. That would be solid. drill through the remaining molded-in insert. I suspect it is aluminum if it corroded. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|