| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| changing hulls http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=8341 |
Page 1 of 1 |
| Author: | dmcdonald [ Mon Nov 19, 2007 4:29 pm ] |
| Post subject: | changing hulls |
i got a different set of hulls for my 16 and i got the tramp frame switched tonight my question is how do you know when the dolphin striker is tight? is there a torque spec? is there anything i can put in the frame where the hulls attach to make future removal easier if ever needed? also shold i just use silicone for the drain plugs or would 5200 be better? thanks for any help. dennis |
|
| Author: | JRagg [ Mon Nov 19, 2007 7:14 pm ] |
| Post subject: | |
Just tighten it until it makes a high pitched twang when you hit it. It'll make a dull noise if it's not tight enough. Too tight and you can mess up the corner castings since they're just aluminum. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|