| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Delam and Gel Coat http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=9380 |
Page 1 of 1 |
| Author: | Hobie Dude [ Mon May 12, 2008 11:44 am ] |
| Post subject: | Delam and Gel Coat |
So yesterday I fixed a small soft spot on my 81 Hobie 16. I did it just as Matt Miller suggested in the FAQ section, with the small breather holes, and the larger injection hole. It went off with out a hitch, a few hours later it was solid as a rock again. My question is with the gel coat. How do I repair the holes I drilled in the deck of my boat. What is working with gel coat like? If anyone can give me a few tips before I do this the hard way it will be very much appreciated. Thanks, Adam |
|
| Author: | abbman [ Mon May 12, 2008 3:30 pm ] |
| Post subject: | |
I had the same question after I did my delam repair. Here is the thread. http://www.hobiecat.com/community/viewt ... ght=abbman Jeremy, as well as everyone else, was very helpful in answering this question. It was really pretty easy. Just drill a dimple in the holes from the delam repair, fill with polyester resin, sand, clean, and gel. Hope this helps some. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|