| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Chips in Comp Tip: what to do? http://www.hobie.com/au/en/forums/viewtopic.php?f=20&t=9665 |
Page 1 of 1 |
| Author: | bock1 [ Sat Jun 07, 2008 6:38 pm ] |
| Post subject: | Chips in Comp Tip: what to do? |
Hi, I just noticed that I've got chips in the comp tip of my mast. The pictures below are the best I could get - but the chips are just in the outer layer of material - not entirely through the tip. What material should I use in the chipped areas to keep the chips from getting deeper or spreading? 
thanks! |
|
| Author: | The Dog [ Sat Jun 07, 2008 7:40 pm ] |
| Post subject: | |
Grey Marine Tex. Or a good marine epoxy like West Systems, that you paint black when you're done. Brian C |
|
| Author: | bock1 [ Sun Jun 08, 2008 4:37 am ] |
| Post subject: | |
Thanks. |
|
| Author: | Sail Revolution [ Sun Jun 08, 2008 12:04 pm ] |
| Post subject: | |
Mix graphite powder into epoxy. Like this: http://www.youtube.com/watch?v=jNwMgX48uwQ |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|