| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Pintle screws http://www.hobie.com/au/en/forums/viewtopic.php?f=23&t=12934 |
Page 1 of 1 |
| Author: | Roy [ Tue Jun 30, 2009 12:36 pm ] |
| Post subject: | Pintle screws |
Could someone please give me the correct size of the screws that go in the transom. I have had so much tiller pull that I need to rake the rudders but if I put a few washers behind the upper rudder mount. But then the screws are too short. -- |
|
| Author: | mmiller [ Tue Jun 30, 2009 3:14 pm ] |
| Post subject: | Re: Pintle screws |
SCREW 12-24 X 3/4 LONG LOCK PHMS It is a custom screw with a locking strip embeded. Use lock washers if changing the screws. We have a 1" version... #8030402 SCREW 12-24 x 1 |
|
| Author: | Roy [ Tue Jun 30, 2009 5:46 pm ] |
| Post subject: | Re: Pintle screws |
thanks Mat!! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|