| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| AFT XBAR END CAP CASTING http://www.hobie.com/au/en/forums/viewtopic.php?f=23&t=55658 |
Page 1 of 1 |
| Author: | sojahseh00 [ Wed Aug 12, 2015 7:19 pm ] |
| Post subject: | AFT XBAR END CAP CASTING |
I have some play in my port side end cap casting(#37201021), is this something I need to be concerned about and there is no way to tighten it without taking the hulls off, correct? |
|
| Author: | RobDek [ Sun Aug 23, 2015 8:40 am ] |
| Post subject: | Re: AFT XBAR END CAP CASTING |
If you have wings attached, I'd be somewhat concerned. Sounds like the rivets have stretched. Take apart, drill out the old rivets and install new ones. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|