I noticed this chipping on the mast where the top section meets the bottom section. How can I repair this chipping and is it dangerous to use as is.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Getaway Mast Chipping http://www.hobie.com/au/en/forums/viewtopic.php?f=23&t=57260 |
Page 1 of 1 |
| Author: | mickey24 [ Sat Apr 02, 2016 6:39 am ] |
| Post subject: | Getaway Mast Chipping |
I noticed this chipping on the mast where the top section meets the bottom section. How can I repair this chipping and is it dangerous to use as is.
|
|
| Author: | mmiller [ Sun Apr 03, 2016 1:35 pm ] |
| Post subject: | Re: Getaway Mast Chipping |
This is cosmetic. Likely either didn't glue the CompTip into the Aluminum extrusion, Fit too tightly at the joint or it has slipped down. The mast bends and leveraged the putty and cracked it. |
|
| Author: | mickey24 [ Mon Apr 04, 2016 6:42 am ] |
| Post subject: | Re: Getaway Mast Chipping |
Thanks for the reply. How would I repair this area, what is the outer shell that is chipping made of. |
|
| Author: | mmiller [ Mon Apr 04, 2016 9:32 am ] |
| Post subject: | Re: Getaway Mast Chipping |
Polyester resin putty. If the mast is glued together, you can grind out a gap all the way round. Then fill the chips. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|