| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Rudder cams and pins http://www.hobie.com/au/en/forums/viewtopic.php?f=23&t=62465 |
Page 1 of 1 |
| Author: | BarbB [ Sun Apr 08, 2018 1:36 pm ] |
| Post subject: | Rudder cams and pins |
I was replacing the port rudder can and it seems that the replacement pin and or screws sent is too short; so we cracked the casting. Now I need to order the casting and CORRECT pin. Can anyone advise the right part number. Our dealer is pretty much a kayak dealer and doesn’t know much about the getaway. I’m in Costa Rica and a fried is coming down so I’m hoping to get the parts to him ASAP |
|
| Author: | mmiller [ Sun Apr 08, 2018 4:53 pm ] |
| Post subject: | Re: Rudder cams and pins |
There are two kits for cam replacement. One for the casting you have and the other for H14 and 16s. Likely you have gotten the H14/16 version in error. You should have gotten 5204 RUDDER CAM KIT H17/18/20 (Getaway too). 50322001 RUDDER CASTING LWR BLACK Comes with a cam installed. z145.jpg)
|
|
| Author: | PurdueZach [ Sun Apr 08, 2018 6:31 pm ] |
| Post subject: | Re: Rudder cams and pins |
mmiller wrote: There are two kits for cam replacement. One for the casting you have and the other for H14 and 16s. Likely you have gotten the H14/16 version in error. You should have gotten 5204 RUDDER CAM KIT H17/18/20 (Getaway too). 50322001 RUDDER CASTING LWR BLACK Comes with a cam installed. Matt, are the cams themselves the same for both kits? |
|
| Author: | BarbB [ Sun Apr 08, 2018 9:52 pm ] |
| Post subject: | Re: Rudder cams and pins |
So I need that plus the cam and pin for the starboard casting I have the cam but the pin is not long enough. What’s the number for the pin? The starboard casting is still good |
|
| Author: | mmiller [ Mon Apr 09, 2018 7:50 am ] |
| Post subject: | Re: Rudder cams and pins |
5203 RUDDER CAM SCREWS H17/18/20 z50.jpg)
|
|
| Author: | BarbB [ Mon Apr 09, 2018 8:15 am ] |
| Post subject: | Re: Rudder cams and pins |
are the cams the same for both the wave and getaway? |
|
| Author: | mmiller [ Mon Apr 09, 2018 8:31 am ] |
| Post subject: | Re: Rudder cams and pins |
Yes. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|