Hobie Forums
http://www.hobie.com/au/en/forums/

getaway jib dimensions
http://www.hobie.com/au/en/forums/viewtopic.php?f=23&t=6669		 Page 1 of 1
Author:  looyenga [ Sun May 06, 2007 1:50 pm ]
Post subject:  getaway jib dimensions
Can anyone tell me the dimensions of the getaway jib? I did a search and couldn't find it. I would like to get a custom Genny made and put a bock just inside the cooler lid for it.
Author:  bowman215 [ Tue Feb 17, 2009 7:56 pm ]
Post subject:  jib
I don't know the dimensions off hand, but could almost be you, if you're looking do put a different jib on it, a H18 jib will work perfectly for where you are going to mount the block. I converted my mast to a H18 (28'1") and put a H18 sail on it, tried the jib, but the foot was too long, went back to the getaway jib (which was more than enough by the way, especially withe huge sail increase), but that's exactly where I would have had to mount the block if I was going to use it. So instead of getting a new one made, think about a H18 jib..... just a thought.
Author:  Sail Revolution [ Tue Feb 17, 2009 11:43 pm ]
Post subject:  Re: getaway jib dimensions
looyenga wrote:
Can anyone tell me the dimensions of the getaway jib? I did a search and couldn't find it. I would like to get a custom Genny made and put a bock just inside the cooler lid for it.


I put the sheet block on the shroud adjuster. The cooler lid isn't strong enough. Look to the very right of this photo.

Image
Author:  bowman215 [ Wed Feb 18, 2009 7:51 am ]
Post subject:  Block
What kind of block did you use?
Author:  Sail Revolution [ Wed Feb 18, 2009 1:53 pm ]
Post subject: 
Image

RF56101 Hobie Catalog
Author:  hobie18rich [ Wed Feb 18, 2009 4:51 pm ]
Post subject: 
Jeremy does nice custom work . He also has his own sails now I'm using them for my F-18 racing sails. We have also changed the whole spin system for the tiger.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/