| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Torqueedo Motor Shaft Length http://www.hobie.com/au/en/forums/viewtopic.php?f=23&t=67399 |
Page 1 of 1 |
| Author: | shogun95 [ Fri Sep 18, 2020 12:33 pm ] |
| Post subject: | Torqueedo Motor Shaft Length |
For those of you with this setup, do you use the long or short shaft motor? Thanks! |
|
| Author: | dorienc [ Wed Sep 23, 2020 1:27 pm ] |
| Post subject: | Re: Torqueedo Motor Shaft Length |
I use the short shaft motor with the KeithB motor mount. I also used it with a Cheata mount previously. If the lake is rough, once in a while I get a bit of cavitation, but not often. |
|
| Author: | shogun95 [ Thu Sep 24, 2020 5:17 am ] |
| Post subject: | Re: Torqueedo Motor Shaft Length |
Thank you! |
|
| Author: | oldyaker [ Thu Sep 24, 2020 9:33 am ] |
| Post subject: | Re: Torqueedo Motor Shaft Length |
Is it best to have the motor level with the water line or angled up a bit? |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|