Just opened the locker hatch to get some water out of the hulls and was looking at the interior. Is this how it's supposed to look?
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hull interior http://www.hobie.com/au/en/forums/viewtopic.php?f=23&t=70421 |
Page 1 of 1 |
| Author: | kokokahi [ Fri Nov 04, 2022 9:31 pm ] |
| Post subject: | Hull interior |
Just opened the locker hatch to get some water out of the hulls and was looking at the interior. Is this how it's supposed to look?
|
|
| Author: | ashus [ Sun Nov 06, 2022 2:47 am ] |
| Post subject: | Re: Hull interior |
Not sure, will stick my phone down my hulls and check this week. |
|
| Author: | mmiller [ Mon Nov 07, 2022 10:07 am ] |
| Post subject: | Re: Hull interior |
That is the second shot of foamy plastic. It can get funky in tight spaces, but its biggest benefit is stiffening the large flat side panels. The keel does not need it. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|