| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Getaway Rudder Cams http://www.hobie.com/au/en/forums/viewtopic.php?f=23&t=9058 |
Page 1 of 1 |
| Author: | Shark11 [ Fri Apr 04, 2008 10:06 am ] |
| Post subject: | Getaway Rudder Cams |
Pre-2007 boats used H14/16 rudder cams correct? |
|
| Author: | sunjammers [ Fri Apr 04, 2008 10:23 am ] |
| Post subject: | |
17 and up part #5204 |
|
| Author: | The Dog [ Fri Apr 04, 2008 2:50 pm ] |
| Post subject: | |
sunjammers wrote: 17 and up part #5204
Brad, that's the cam kit p/n. 5204 and 5202 both have the same cams. It's the sister screws that are different. The Cam for the Getaway is the same. Only the old pre-'87 18 rudder systems had a different cam. The old Getaways do use the longer sister screw found in the 5204. Or you can buy the sister screws stand-along using 5203. Brian C |
|
| Author: | sunjammers [ Fri Apr 04, 2008 9:33 pm ] |
| Post subject: | |
yea I just assumed he needed the whole kit on that new of a boat, doubt they've been changed out yet from factory rivet. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|