| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| pin in mast base http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=13055 |
Page 1 of 1 |
| Author: | seapinesailor [ Mon Jul 13, 2009 10:31 am ] |
| Post subject: | pin in mast base |
while de-rigging my Wave, the mast crashed down and came loose from the step ball, damaging the ball. I bought a new ball, however, I can't get the pin out from the mast base so as to fit the mast over the ball. How can I remove the pin? |
|
| Author: | mmiller [ Mon Jul 13, 2009 11:21 am ] |
| Post subject: | Re: pin in mast base |
Likely the mast rotated 90 degrees while lowering. This would cause the ball to be pryed out of the mast base. Now... how to get it out. Maybe a hammer and a straight punch. |
|
| Author: | scuzzlebutt [ Tue Jul 14, 2009 7:57 am ] |
| Post subject: | Re: pin in mast base |
Bolt cutters or hacksaw? |
|
| Author: | shogun95 [ Wed Jul 15, 2009 2:31 pm ] |
| Post subject: | Re: pin in mast base |
Dremel |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|