Cracked one of these:
Can't see it but it's at the rivet. Got part 80550005. Few install instructions. New part has different location holes. Do you punch new holes in the sail?!!
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Batten protector replacement? http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=20549 |
Page 1 of 1 |
| Author: | JJ [ Wed Feb 03, 2010 9:52 pm ] |
| Post subject: | Batten protector replacement? |
Cracked one of these: Can't see it but it's at the rivet. Got part 80550005. Few install instructions. New part has different location holes. Do you punch new holes in the sail?!! |
|
| Author: | JJ [ Thu Feb 04, 2010 9:38 am ] |
| Post subject: | Re: Batten protector replacement? |
At the 17:19 mark of this video: http://www.sailrite.com/Full-Batten-Poc ... tion-Video is the install of the batten protector. They use an awl! Whooooooooo |
|
| Author: | mmiller [ Thu Feb 04, 2010 10:15 am ] |
| Post subject: | Re: Batten protector replacement? |
If you use the "Hobie" pocket protector (which is # 12480001)... the holes are in the same location. |
|
| Author: | JJ [ Thu Feb 04, 2010 10:51 am ] |
| Post subject: | Re: Batten protector replacement? |
Where is 12480001 in the catalog? hmmm, I see. Listed with H16 and up schematics, not Wave. 80550005 listed also. And if you double-click on the picture, the crack is visible. Does the 1248001 use rivets or screws? |
|
| Author: | mmiller [ Thu Feb 04, 2010 11:13 am ] |
| Post subject: | Re: Batten protector replacement? |
No all parts are shown on all pages... lots of duplication, yes, shown on the 16 page. Rivets come with the kit. Two caps and 5 rivets. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|