| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Cracks inside hulls http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=47559 |
Page 1 of 1 |
| Author: | CA Newbie [ Sun May 12, 2013 4:13 pm ] |
| Post subject: | Cracks inside hulls |
Hi, I recently bought used Wave and noticed cracks inside the hulls in material that wrapped/sprayed from inside the hull around the tubes which hold rear crossbar in hull (see photos below). I have two questions about it: How crucial it is (in other words is boat still sailable)? Is it repairable? Thanks! Photos of cracks:  
|
|
| Author: | mmiller [ Mon May 13, 2013 9:50 am ] |
| Post subject: | Re: Cracks inside hulls |
Material here is just a water barrier, so not a structural issue. The black showing is the sleeve, so not a water leak area either. |
|
| Author: | CA Newbie [ Mon May 13, 2013 3:19 pm ] |
| Post subject: | Re: Cracks inside hulls |
mmiller wrote: Material here is just a water barrier, so not a structural issue. The black showing is the sleeve, so not a water leak area either. Thank you very much Matt!
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|