| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Aluminium two pieces mast http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=57991 |
Page 1 of 1 |
| Author: | samo [ Wed Jun 15, 2016 11:02 pm ] |
| Post subject: | Aluminium two pieces mast |
Hello to all. Last time I was sailing with my Hobie Wave some gusts over 30 knots hits me and now Mast where the joint is isn't tight any more. Is this a common thing by Aluminium mast? It is not much just a little.. |
|
| Author: | mmiller [ Tue Jun 28, 2016 8:49 am ] |
| Post subject: | Re: Aluminium two pieces mast |
Not common to be very loose, but the joint is s slip fit to allow assembly and disassembly. You could add some epoxy to the CompTip and file to fit tighter. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|