Hobie Forums
http://www.hobie.com/au/en/forums/

Wave crossbars
http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=59344
Page 1 of 1

Author:  cooldudecaptain [ Tue Oct 18, 2016 1:59 pm ]
Post subject:  Wave crossbars

Again, my Wave has been in storage for quite a while. I removed the tramps to clean them and noticed the front and rear crossbars slide a little into and out of each hull. There are no end caps for the crossbars because I also have the 'back rests'.

Should there be some give in these crossbars ? Does anything actually anchor them inside the hulls ? Obviously, when the tramps are installed and laced up the tension created stops any crossbar movement.

Input ?

thanx,
bill

Author:  mmiller [ Tue Oct 18, 2016 2:48 pm ]
Post subject:  Re: Wave crossbars

Only the trampoline tension holds a Wave platform together. Add the rig and placed under tension locks it all together even tighter.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/