| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| EZ Rudder Rivets http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=59887 |
Page 1 of 1 |
| Author: | cdoch [ Mon Feb 06, 2017 12:01 am ] |
| Post subject: | EZ Rudder Rivets |
Can anyone please give advise on how to use these rivets? They are tube rivets not pot rivets part number 50313301. Thanks |
|
| Author: | mmiller [ Mon Feb 06, 2017 3:16 pm ] |
| Post subject: | Re: EZ Rudder Rivets |
You need to flair the hollow end and then hammer flat. Use a rounded punch. I made one from a piece of rod stock and ground the end round. Used that to hammer on the hollow end to flair it. Then finish by hammering the edges flat. |
|
| Author: | cdoch [ Mon Feb 06, 2017 5:59 pm ] |
| Post subject: | Re: EZ Rudder Rivets |
Thanks Matt. Cheers |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|