| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| A little customization on 4:1 mainsheet blocks http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=61387 |
Page 1 of 1 |
| Author: | rorr [ Fri Aug 25, 2017 5:57 am ] |
| Post subject: | A little customization on 4:1 mainsheet blocks |
Sailing my new used Wave with the stock 4:1 mainsheet blocks. The boat came with a pretty tattered mainsheet. I was lucky enough to find a 30' piece of 8mm New England Rope Buzz Line (poor man's Salsa) in the APS end of spool bin. I have the cleat in the top position to prevent an accidental cleating, but at that angle I found the flairlead over the cleat gave little space for the 8 mm line to run through. I added a couple of 1/2 nylon spacers between the cleat and flairlead. This also helps when uncleating because the line has more room to snap down. Here's a photo. https://goo.gl/photos/evRugcThx9Rua8KY8 |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|