| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Will ClubWave standing rigging work on a ClassicWave? http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=64600 |
Page 1 of 1 |
| Author: | bwinston [ Wed Apr 24, 2019 8:48 am ] |
| Post subject: | Will ClubWave standing rigging work on a ClassicWave? |
I would like to upgrade the standing rigging on a ClassicWave with ClubWave standing rigging. How about it? |
|
| Author: | mmiller [ Wed Apr 24, 2019 11:54 am ] |
| Post subject: | Re: Will ClubWave standing rigging work on a ClassicWave? |
It will work. You may need to alter the shroud chain plates (Drill) to accept a 1/4" clevis pin. Depending on the age of the boat the bow eyes may be difficult to remove for bridle installation. YOu might have to add shackles there. Parts are listed on the parts diagram: https://static.hobiecat.com/digital_assets/Wave_March_2017.pdf#page=3 |
|
| Author: | bwinston [ Wed Apr 24, 2019 12:03 pm ] |
| Post subject: | Re: Will ClubWave standing rigging work on a ClassicWave? |
Thanks Matt, I really appreciate this forum and your quick reply. |
|
| Author: | sixkush [ Thu Apr 27, 2023 6:49 am ] |
| Post subject: | Re: Will ClubWave standing rigging work on a ClassicWave? |
mmiller wrote: It will work. You may need to alter the shroud chain plates (Drill) to accept a 1/4" clevis pin. Depending on the age of the boat the bow eyes may be difficult to remove for bridle installation. YOu might have to add shackles there. Parts are listed on the parts diagram: https://static.hobiecat.com/digital_assets/Wave_March_2017.pdf#page=3 Could one use a 3/16 clevis pin and still use the existing chain plates on the Classic? |
|
| Author: | mmiller [ Fri Apr 28, 2023 12:50 pm ] |
| Post subject: | Re: Will ClubWave standing rigging work on a ClassicWave? |
You could use the existing adjusters and the 3/16" pins. |
|
| Author: | Wavesurf57 [ Sat Apr 29, 2023 4:31 pm ] |
| Post subject: | Re: Will ClubWave standing rigging work on a ClassicWave? |
Id like to add that drilling your chain plates and changing all pins to 1/4 (6mm) is a good upgrade if you sail in higher winds. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|