| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Questions: replace bridle wires and batten tie-in line http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=66314 |
Page 1 of 1 |
| Author: | lurker [ Mon Apr 06, 2020 11:37 am ] |
| Post subject: | Questions: replace bridle wires and batten tie-in line |
I have a couple of questions for which I thank any responders in advance. 1. Where can I buy batten tie-in line for my Hobie wave? I have looked everywhere and no-one seems to stock it. 2. The bridles attach to the forward end of the hulls with a metal fitting that is screwed down. I want to replace the bridles. Would I be correct that the screws can simply be unscrewed to remove the metal fitting? I don't want to hear a small sound of a nut inside the hull dropping off when I unscrew. Thanks |
|
| Author: | mmiller [ Mon Apr 06, 2020 4:33 pm ] |
| Post subject: | Re: Questions: replace bridle wires and batten tie-in line |
Yes, you unscrew the padeye to remove the Bridle wire. If you have corrosion issues... You could cut them off and use a shackle If you can't remove the screws. Batten tie line is carried by many dealers. It is RH112WHT 18" PER TIE. This is 1/12" line. |
|
| Author: | lurker [ Tue Apr 07, 2020 8:57 am ] |
| Post subject: | Re: Questions: replace bridle wires and batten tie-in line |
Thanks Matt. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|