| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Wave beam at bottom? http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=6753 |
Page 1 of 1 |
| Author: | Kevin Pierce [ Wed May 16, 2007 5:24 pm ] |
| Post subject: | Wave beam at bottom? |
I know from the Hobie website that the beam of the Wave is 7 feet. Could someone tell me the distance between the skegs (?) at the hull bottoms (which would be the same as the distance between rollers on a trailer)? I want to make certain a Wave will fit over the fenders on a Trailex 16 catamaran trailer, which would require about 70 inches. Kevin |
|
| Author: | The Dog [ Thu May 17, 2007 8:46 am ] |
| Post subject: | |
Outside edge to outside edge on the stub keels at the back looks to be 69.25 inches. Brian C |
|
| Author: | Kevin Pierce [ Thu May 17, 2007 9:18 am ] |
| Post subject: | |
Brian: Many thanks. Looks like the Wave would just clear the fenders. And the rollers probably hold it above them, anyway. Best, Kevin |
|
| Author: | The Dog [ Thu May 17, 2007 10:09 am ] |
| Post subject: | |
Kevin, You need to remember that the hulls flare out fairly quickly from the center line of the hull. Be prepared to improvise. Brian C |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|