| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Using hobie 16 shroud adjusters on wave http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=69388 |
Page 1 of 1 |
| Author: | Wavesurf57 [ Sat Jan 01, 2022 1:46 pm ] |
| Post subject: | Using hobie 16 shroud adjusters on wave |
Happy New year Rockers, I was think of beefing up my shrouds to accept the 6mm pins as i just don't trust the 4 mil ones when I'm out in “certain conditions”. Does anyone know any cons of that setup? Thanks. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|