| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Replacing threaded mast post http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=69990 |
Page 1 of 1 |
| Author: | Vera [ Sun Jul 03, 2022 4:44 pm ] |
| Post subject: | Replacing threaded mast post |
I need to replace the threaded post for the mast on a Hobie Wave. The mast ball came of easily, but I can't get the the other end of the threaded post out of the mast step. Any suggestions. Thanks. |
|
| Author: | mmiller [ Thu Jul 07, 2022 4:04 pm ] |
| Post subject: | Re: Replacing threaded mast post |
Pipe wrench and leverage. |
|
| Author: | Bob Curry [ Mon Jul 11, 2022 3:34 pm ] |
| Post subject: | Re: Replacing threaded mast post |
Add PB Blaster then pipe wrench and leverage as Matt recommends! |
|
| Author: | Vera [ Wed Jul 13, 2022 3:54 pm ] |
| Post subject: | Re: Replacing threaded mast post |
Thanks, the pipe wrench did the trick. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|