| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| "I'm back, I'm back in the saddle again" http://www.hobie.com/au/en/forums/viewtopic.php?f=24&t=70343 |
Page 1 of 1 |
| Author: | CA Newbie [ Tue Oct 04, 2022 3:15 pm ] |
| Post subject: | "I'm back, I'm back in the saddle again" |
I bent my mast in storm in May, and had real trouble ordering new one (they are out of stock everywhere). However, thanks to someone from this forum, who pointed out that Hobie 14 uses the same extrusion, I was able to get new lower mast by cutting it from Hobie 14 mast! Thanks to Matt for helping with exact extrusion measurements too! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|