Hobie Forums
http://www.hobie.com/au/en/forums/

My Hobie Hull has a curve in it. Anyone notice similar?
http://www.hobie.com/au/en/forums/viewtopic.php?f=26&t=14526
Page 1 of 1

Author:  Billy V [ Sun Sep 06, 2009 9:28 pm ]
Post subject:  My Hobie Hull has a curve in it. Anyone notice similar?

I recently had a Revolution Hull replaced under warranty, but the new replacement hull has a curve to the left near the bow. I definitely think its curved enough to affect the tracking of the boat in the water.

I have not put the new hull in the water yet, and I'm kind of bummed I have a curved kayak.

Has anyone else noticed any abnormality in their hulls, any curves near the bow ?

I have held off on any rigging until I get some feed back as to the Hulls condition.

Author:  Ron Papworth [ Tue Sep 15, 2009 2:43 pm ]
Post subject:  Re: My Hobie Hull has a curve in it. Anyone notice similar?

Probably ought to think about calling Hobie tech support and ask them what you should do. Maybe you got a bad one and they will just replace it "again"?

Author:  mmiller [ Tue Sep 15, 2009 4:20 pm ]
Post subject:  Re: My Hobie Hull has a curve in it. Anyone notice similar?

This could be a slight sunken area near the bow that makes it appear to bend to one side. Possible and most likely... and if so, easily corrected. Never heard of a bend that altered steering. Contact your dealer first and foremost with this type of concern. That is why they are there.

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/